Planning | Week #1

-
Beginning of class:
Teacher Mario Shimanuki gave the initial concepts on resistors
•Voltage
• How Ohms Law Works
• Prototyping board.

Continuing the Lesson:
Closing with the Led example.
The students Diana and Claudia helped in the project bringing the main topics:
• Fundamentals of Arduino Programming
• Variables and constants
• Multiple choice commands
• Declaration of variables Vectors and matrices
• Election commands
• Repeat commands
• Tinkercad.
• While
• Do while (Repeat, until).
• Arduino Software
• Where to get the program
• Programming Cycle
•First contact

What did we do:
• Creating a Tinkercad account
• Tinkercad simulation of how a Led lights up.

Popular posts from this blog

Future Tasks | Week #3

-
Tasks : We added some task to accomplish as soon as possible , that is record and edit a video showing how our project works . We have discussed about it and we got in an agreement , and for the next week we will produce the video . So we have finished the video we are going to keep doing the arduino project , doing the code , and see how it really works , we have already done a lot of improvements but we're getting it better . What will be used ? In Easy Light's project we are going to use : The Arduino  Arduino Board (UNO MEGA 2560 R3)  Easy VR Shield Arduino -LEDS  Serial Modul WiFi ESP8266 ESP-01  Light Sensor LDR Transistors The Video GoPro Camera Wheelchair Mess
Read more

Barriers and Issues | Week #4

-
All along the development of the project we've found some challenges to face and find a solution . It was hard to find a way to overcome those situations but with patience we achieved our goals . Barriers The great challenge we've found by doing the project were the limited resources to develop our project and with it , we couldn't finish what first was promissed .
Read more

Practice Class | Week #3

-
The class We had a practice class to show how to turn on a led through a Arduino board,  guided by the students Mrs.Claudia and Mrs.Diana , and the teacher Mr.Calebe . What happened ? We started to build the whole Arduino sytem , with the part of the codes and concrete part , to turn on a Led , after we keep enhacing the project adding a buzzer (a component that makes noise) , and light sensor (a component that verifies the light and depending on , turn off or on the led .). The class went good , up to we try to run the code program , but some Computers weren't recognizing the Arduino boards . We had to change the computers that we were running the code for others , to try to recognize the Arduino board . We have finished the class with a practice example of how a modded walking stick, that recognize obstacles and vibrates when we are close to it . It was composed by an arduino board , a protoboard , and an obstacle sensor which was measured by the distance .
Read more